2016 October Cisco Official New Released 300-101 Dumps in Lead2pass.com!
100% Free Download! 100% Pass Guaranteed!
Your worries about 300-101 exam completely no more exist, because Lead2pass is here to serves as a guide to help you pass the exam. Lead2pass offers the latest 300-101 PDF and VCE dumps with the new version VCE player for free download. All the 300-101 exam questions and answers are the latest and cover every aspect of 300-101 exam. It 100% ensures you pass the exam without any doubt.
Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/300-101.html
The Dev-1 and Dev-3 routers are OSPF neighbors over the Ethernet 0/0 connection. Based on the show ip ospf neighbor output from the Dev-1 and Dev-3 routers, which statement is true? Select the best response.
A. Dev-1 is the DR because it has a higher OSPF router priority.
B. Dev-1 is the DR because it has a lower OSPF router ID.
C. Dev-3 is the DR because it has a higher OSPF router priority.
D. Dev-3 is the DR because it has a lower OSPF router ID.
E. Both Dev-1 and Dev-3 are using the default OSPF router priority.
During a recent OSPF election among three routers, RTA was elected the DR and RTB was elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place of the DR while RTC becomes the new BDR. What will happen when RTA comes back online?
Select the best response.
A. RTA will take the place of DR immediately upon establishing its adjacencies.
B. RTA will take the place of DR only if RTB fails.
C. RTA will take the place of DR only if both RTB and RTC fail.
D. A new election will take place establishing an all new DR and BDR based on configured priority
levels and MAC addresses.
By default, which statement is correct regarding the redistribution of routes from other routing protocols into OSPF? Select the best response.
A. They will appear in the OSPF routing table as type E1 routes.
B. They will appear in the OSPF routing table as type E2 routes.
C. Summarized routes are not accepted.
D. All imported routes will be automatically summarized when possible.
E. Only routes with lower administrative distances will be imported.
Type E1 external routes calculate the cost by adding the external cost to the internal cost of each link that the packet crosses while the external cost of E2 packet routes is always the external cost only. E2 is useful if you do not want internal routing to determine the path. E1 is useful when internal routing should be included in path selection. E2 is the default external metric when redistributing routes from other routing protocols into OSPF.
What are three key concepts that apply when configuring the EIGRP stub routing feature in a hub and spoke network? (Choose three.)
A. A hub router prevents routes from being advertised to the remote router.
B. Only remote routers are configured as stubs.
C. Stub routers are not queried for routes.
D. Spoke routers connected to hub routers answer the route queries for the stub router.
E. A stub router should have only EIGRP hub routers as neighbors.
F. EIGRP stub routing should be used on hub routers only.
An administrator types in the command router ospf 1 and receives the error message:
“OSPF process 1 cannot start.” (Output is omitted.)
What should be done to correctly set up OSPF? Select the best response.
A. Ensure that an interface has been configured with an IP address.
B. Ensure that an interface has been configured with an IP address and is up.
C. Ensure that IP classless is enabled.
D. Ensure that the interfaces can ping their directly connected neighbors.
Which three benefits does the Cisco Easy Virtual Network provide to an enterprise network? (Choose three.)
A. simplified Layer 3 network virtualization
B. improved shared services support
C. enhanced management, troubleshooting, and usability
D. reduced configuration and deployment time for dot1q trunking
E. increased network performance and throughput
F. decreased BGP neighbor configurations
The enterprise network WAN link has been receiving several denial of service attacks from both IPv4 and IPv6 sources. Which three elements can you use to identify an IPv6 packet via its header, in order to filter future attacks? (Choose three.)
A. Traffic Class
B. Source address
C. Flow Label
D. Hop Limit
E. Destination Address
F. Fragment Offset
Which traffic characteristic is the reason that UDP traffic that carries voice and video is assigned to the queue only on a link that is at least 768 kbps?
A. typically is not fragmented
B. typically is fragmented
C. causes windowing
D. causes excessive delays for video traffic
Refer to the exhibit. Which statement about the configuration is true?
A. 20 packets are being sent every 30 seconds.
B. The monitor starts at 12:05:00 a.m.
C. Jitter is being tested with TCP packets to port 65051.
D. The packets that are being sent use DSCP EF.
Refer to the exhibit. Which statement about the command output is true?
A. The router exports flow information to 10.10.10.1 on UDP port 5127.
B. The router receives flow information from 10.10.10.2 on UDP port 5127.
C. The router exports flow information to 10.10.10.1 on TCP port 5127.
D. The router receives flow information from 10.10.10.2 on TCP port 5127.
Pass 300-101 exam with the latest Lead2pass 300-101 dumps. Lead2pass 300-101 exam questions and answers in PDF are prepared by our expert. Moreover, they are based on the recommended syllabus that cover all the 300-101 exam objectives. Comparing with others’, you will find our 300-101 exam questions are more helpful and precise since all the 300-101 exam content is regularly updated and has been checked for accuracy by our team of Cisco expert professionals. Welcome to choose.
300-101 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDeXZ6R3kxS05wV0E
2016 Cisco 300-101 exam dumps (All 183 Q&As) from Lead2pass:
http://www.lead2pass.com/300-101.html [100% Exam Pass Guaranteed]
|One Time Purchase||✔||✖||✖||✖||✖|
|100% Pass Guarantee||✔||✖||✖||✖||✖|
|100% Money Back||✔||✖||✖||✖||✖|